Tab- Refill - Shiny Date and standard (S-5XX) Stamp REFILL PAD page Instructions Page:301076

Choice of teacher stamp ink colourInk Specification: The refill ink for Shiny rubber stamps (including date stamps) is a specialist ink for rubber stamps only. Purchase either as a 10ml ink bottle to replenish an existing pad or as a full replacement ink pad (for the same or an alternative colour).
refresh-button.jpgHow to Refill a Shiny Self-inking Rubber Stamp
1. Release pad:
- Models: S854/S855  - push the front red button to release the pad. 
- Models: S510/S520/S530/S542/S829 and similar - whilst holding the red locking buttons, gently push the handle down until the stamp locks. Remove the pad by pushing it from the front (noting the direction of the ink pad).
- Models: PET-300, PET-400, R512 - push the pad out from the front
Shiny Rubber Stamp - Refill InstructionsBottle ink instructions:

2. Apply a few drops only to the pad - amount varies by size of pad. This refreshes the pad which in turn inks the rubber. Be careful not to over fill the pad.
3. Once the ink has all been absorbed, push the pad back into place.
4. Start using after around 10 minutes.

Replacement pad instructions (same colour):

2. Remove the pad - note it's orientation for reinsertion.
3. Replace with the new pad ensuring the pad is inserted the correct way up.
4. Start using straight away.

Replacement pad instructions (different colour):

2. Remove the pad - note it's orientation so you can replicate it with the new pad.
3. Stamp out the mount on scrap paper to clean the rubber image plate.
4. Once no ink impression prints insert the new pad.
5. Start using straight away.

Stamp refill videoVideo:  Coming soon!
Important stamp refill ink notes

Important Stamp Refill Ink Notes:
- Always refill with the correct ink for your stamp. Ink specifications vary and the wrong ink could ruin your stamp.
- Refilling with a different colour ink onto the existing stamp pad does not change your stamp's colour.