Refill Stamp Offer: May only be purchased with a stamp order.
Extend the life of your Xstamper - Xclamations, Capless, 3-in-1 twist stamp and Kiss stamp with this refill ink which can be used to replenish stampers approximately 15-20 times. Stamper refill instructions below.
- 10ml bottle which will refill approx 15-20 stamps
Xstamper Xclamations Refill Instructions:
- Remove the handle by pulling it away from the base inside you will see the Ink Pad, apply just a few drops of ink on to this to refresh the pad which in turn inks the rubber. Make sure the ink is the same colour as the original stamp
- After re-inking, leave your stamp in an upright position to allow complete absorption (approx. 12 hours).
Xstamper 3-in-1 Refill instructions:
- Slide the brick out of the mount and pour a couple of drops of ink into the open area as illustrated in the diagram underneath the main image (expand by clicking the thumbnail to enlarge).
- As above, after re-inking, leave your stamp in an upright position to allow complete absorption (approx. 12 hours).
Xstamper KISS Stamp Refill Instructions:
- Remove the dust cap then pull the top and bottom of the mount apart.
- Pull the black stopper from the unit to reveal the ink pad.
- Remove the ink unit and place 2 to 3 drops of ink onto the pad.
- Return the ink unit to the mount.
- After re-inking, leave your stamp in an upright position to allow complete absorption for 2-3 hours, ideally overnight